Detail: I have a new 2010 Hyundai Santa Fe with the bluetooth package. I paired my Verizon cell with it and it will make the call fine. The problem comes when I disconnect. I get a beep from the system that won't go away. It won't let me change to radio, navigation or anything else. Any ideas??
Solution: Turn your phone off . , Hi, a 6ya Mechanic can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck! , its your serpentine belt (thats what its called) and you will need a 3/8 ratchet and then find the belt tensioner. The tensioner has a spot where you need to put the ratchet into and pull or push depending on whatever way and that will releive the pressure off the belt so you can take it off. , Most likely the o-ring seal between the torque converter and the transmission is going bad. Get that transmission rebuilt pronto before serious damage is done! But first, have a mechanic drop the transmission pan and look for signs of a very thin silvery film coating the inside of the pan. If found, then the transmission definitely will have to be rebuilt, and the torque converter will also have to be replaced since embedded metallic particles in the old torque converter will eventually come loose, due to wear of the clutch plates within the torque converter, and eat up the rebuilt transmission. Now, here is the deal once the transmission has been rebuilt: Change the transmission fluid and filter once a year -- no matter what! If you do this, then you should never have any more problems with the transmission. , If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by. Hope this is of some help. Ed , Remove the plastic cover that goes over the engine (the one with the Hyundai logo). At this point, you will see the cables that goe to each fo the spark plugs. Noting their position, remove them. The spark plugs are ready to be removed, turn counterclockwise and replace with manufacturer recomended ones. , This is from the factory service manual of your car: There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.