Detail: 2012 chrysler grand voyager 2.8crdi not changing gears now initially was just having the lightning light on in red and now the gear only stays in one ger
Solution: Most current automatic transmissions will be put into a "limp" mode if the electronics detect a fault in the transmission. That is, the transmission will go into one gear (usually second or third depending on how many speed ranges the transmission has) and allow you to drive it slowly to a service department or transmission shop. The intent is to prevent further damage by continuing to drive with the problem. It's possible the problem is relatively minor and inexpensive to repair, but continuing to drive it will almost certainly cause more damage (and be more expensive) to repair. , Hi, A 6ya expert can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US. The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones). click here to download the app (for users in the US for now) and get all the help you need. Good luck! , One of the shift solenoids in transmission has caused a code and needs to be fixed or replaced by sounds of it. You are currently in what they call "limp mode". Take it to a dealer or tranny shop (reputable) have it scanned, and get a quote for repairs, and decide from there. Letting someone who doesn't know these transmissions play with it now, will certainly end up costing you a new or rebuilt one needing to be installed. If not taken to a dealer, and fluid & filter is changed, be sure to insist on Mopar ATF 4 transmission oil, and nothing else, should be used on it. , Hi: This same thing happened to my daughter,s car, and it ended up being fixed with a transmission speed sensor. This sensor not only runs the speedometer, it helps tell the transmission when to shift too. , Yes,check wheel speed sensor or whire on that wheel , leave the power on for 30mins and the lock will turn of then enter the code , Does you speedometer work?