How do you Reset brain on 96 cutlass supreme so it no longer

Detail: How do you Reset brain on 96 cutlass supreme so it no longer locks braking system
Detail Question How do you Reset brain on 96 cutlass supreme so it no longer

Solution: Hi, a 6ya Mechanic can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck! , It physically will fit and bolt up,but there are many different ratio,and drive and driven sprocket tooth counts,different final drive ratios,all monitored by the computer with electronic speed sensors.If the trans from the 95 has a different ratio than the 93,the computer will set gear ratio error codes,and possibly put the trans in a failsafe mode,stuck in 2nd or 3rd gear.On the transmission case,down by where the passenger side axle would go in,is a thin metallic tag,maybe 2"x 3",and it has bar codes,and also a series of numbers and letters.The numbers and letters,large cap,are the final drive gear ratio code.They should match on the two transmissions in question. , If the lights on the dash all come on but the engine wont turn over it could be a problem with the VAT security system. Your key has a little chip on it between the teeth and the handle. This is a common problem with GMs', often just replacing the key is necessary but sometimes the VAT module needs to be replaced. , I just had to do this to my cutlass supreme. It is fairly easy. First, you need to jack the car up in the rear (but dont forget to put wheel chocks in front of the front wheels to prevent any chance of rolling, and break all of the lug nuts loose while the car is still on the ground, and put jack stands under it to keep the car raised safely) and remove the rear wheels. Then look at where the strut mounts to the wheel, there are two bolts holding it on the wheel assembly; remove those (you may need to jack ut the suspension to remove the bolts). Now locate the two smaller bolts to each side of the the strut itself on the strut mount, holding it to the car (this is located at the very top of the wheel well) and remove them. Now u can compress the strut by hand and wiggle it free from the car. Once u have the old strut out, remove the large nut that is securing the strut to the mount. In some cases this is impossible to do due to the rust that has binded them together. If this happens, you will need to purchase a new strut mount for your new strut. AutoZone seems to be the cheepest place for parts. To install the new struts just do everything backwards. When the new struts are installed, the wheels may be slanted down. If this is the case, do not worry, they just need time to "relax" or be broken in. I hope everything goes smoothly and i wish you luck. , sounds like a bad or loose ground wire, it would be located in the trunk near the tail light assembly, the other switch is for the cruise contro, it's what cuts the cruise when you hit the brakes. , Try having someone push on brake pedal at the same time thay move the turn signal lever up and down slightly to see if your brake lights work this would tell me that you have a faulty turn signal switch because GM runs the brake lights thru the turn signal switch so they work if you are driving with your 4way flashers on.

By entering you agreed with our Terms of use and Privacy Policy.If you do not agree, please do not use this service or you will face consequences.
This site powered by Express JS, node.js, MongoDBand advanced javascript algorithm include all npm modules
Copyrighted © 2015