Detail: Have a 2000 Chevy S10 pickup change the transmission to a transmission and it it won't turn over it starts but it won't turn over what do I do
Solution: Your question makes no sense , Hi, a 6ya Mechanic can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck! , Yes it screws in on right side of tramission and you will need a 7/8 inch deep socket to remove it. You may be able to clean the old one once it is removed. There is a little ball thatgets dirty and may you can get by with cleaning it. Good Luck. Ed , sounds like ignition module inside of distributor cap under distributor rotor button.these do go bad and can easily be replaced.strong suspicion from your details that this is the culprit. , Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don , your transmission has possibly been rebuilt with stronger springs put in. No worries. have been running mine for along while without any problems. Better this than slipping, but it is a bit annoying. , I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months. I assume you have a 4.3L and not the 2.2L? For the 4.3L: Firing Order: 1-6-5-4-3-2 Cylinders: 6-----------5 4-----------3 2-----------1 (front of vehicle) Distributor: coil wire--> -----6------->............<--------5------- -----4------->............<--------1------- -----2------->............<--------3------- ............(front of vehicle) Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!