SOLVED: Right brake light stopped working. Not the bulb..

Detail: Right brake light stopped working. Not the bulb.. any ideas
Detail Question SOLVED: Right brake light stopped working. Not the bulb..

Solution: Could be the socket,the ground and if the brake and signal light use the same bulb ,it could be in the turn signal switch.don't forget ,new bulbs don't always work. , Hi, a 6ya Mechanic can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck! , take the bulb back out have someone sit in car apply brake get your self a circuit tester and check to see if this circuit is carrying efficient 12 volt current! some times in cold weather these bulbs get hot with long period of breaking and when released condensate and rust begins and you get what you have perhaps bad socket! this would be a ideal location to begin and probably end, , These are Dual Function Bulbs. They control the Parking Lights and the Brake Lights. This Bulb is Burnt out on the Brake Coil inside the Bulb. I have actually seen Bulbs that were Bad But you could not Tell by jast looking at them. It should be fine with a New Bulb. Please Rate My Response! Thanks! , most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine , You have to check the brake light switch which should be around the brake pedal on the upperside. Ones located rremove the wires tht go to the switch and jump them by using a piece of wire, thn check if the brake lights come 'on'. If they do , thn its the switch tht may need replacing or even sometimes adjusting inorder to operate. Hope this helps. , In my own personal experience, you should first adjust the nuetral safety switch, it controls the reverse lights. After that, remove the jaw clip from the back of the tail ight, clean the connections, and the take a thin pick, and close the 2 metal pins together in the different sections of the jaw, with enough space between them to plug them back in. The connections inside the clip tend to expand away from the printed tail light curcuit over time.

By entering you agreed with our Terms of use and Privacy Policy.If you do not agree, please do not use this service or you will face consequences.
This site powered by Express JS, node.js, MongoDBand advanced javascript algorithm include all npm modules
Copyrighted © 2015