SOLVED: Why speedometer and rpm igle starts jumping after

Detail: Why speedometer and rpm starts jumping after switching on the engine
Detail Question SOLVED: Why speedometer and rpm igle starts jumping after

Solution: You can set it to do that or not do it. It's explained in your owners manual. , Hi, a 6ya Mechanic can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck! , the alarm turned off as soon as you unlock the door with the key... the clicking noise could just be the fact that your battery is dead. hope i was some help , Last night I checked the battery and it was still good. I disconnected and then reconn ected both terminals and that brought the power back. When I turned the key the power went out again. I repeated the procedure but did not turn the key. Instead, I took off the knee bolster and tried to wiggle the wires under the dash to see if I could find the source since it seems to be related to the ignition. Nothing cut the power so I started it up and it worked fine except for the check engine light which was flashing that says I have a misfire condition. I drove the car 25 miles to work this morning and will be taking it to the dealer for a better inspection. , hi there, your alternator is not putting out enough, subbies should put out about 14.4v and just after starting should put out 40-60amps. charge the batt that is in it now with a small (3.5-6amp) charger overnight then start the car and LOAD TEST the batt and alternator at a battery shop. ask them to put a carbon pile load tester on your system. im pretty sure they're gonna tell you its the alternator. many thanks, hope this helps! , ended up being the fuel pump and the knock sensor , I finally fixed mine, on my 1999 Subaru legacy 30th anniv edition. . . I removed the speedometer head, and resoldered the green connector on the board. Then I also ran a wire to duplicate the trace wire from the middle pin to the first connect (about 4mm). Problem gone. email for more details if interested: mike(at)whiteley.org

Latest Searches

By entering you agreed with our Terms of use and Privacy Policy.If you do not agree, please do not use this service or you will face consequences.
This site powered by Express JS, node.js, MongoDBand advanced javascript algorithm include all npm modules
Copyrighted © 2015