Detail: How do I replace a head gasket on my 97 buick regal
Solution: You may want to check this video. Labor costs to change head gasket for buick park ave Yahoo Answers ( check this one out as well ) , Get a chiltons or haynes repair manual, the info you need is there. , Hi, a 6ya Mechanic can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck! , It's just an error message. It stands for Error 20. There is no way to fix the problem. It only reads cd's that it wants. But if it does play a cd, then suddenly stops, and says E20 and spits the cd out, it's most likely because the cd player got too hot. My car does that all the time. And it won't play a lot of burned cd's. Hope this helped. , i think you need to remove pully first it is a special puller gm has , The starter is on the underside of the transmission, there are wires feeding the solenoid (remove) 3 starter bolts (remove) pull off transmission/flywheel , GM Lumina/Grand Prix/Cutlass Supreme/Regal 1988-1996 Headlight Switch - REMOVAL & INSTALLATION Except With Head Up Display (HUD) (see Figures 1, 2, 3 and 4) Fig. 1: Headlight switch location and mounting-1988 Regal shown Fig. 2: The headlight switch is secured with clips and screws-1990 Lumina shown Fig. 3: Light switch location and attachment-1993 Cutlass Supreme Fig. 4: Headlight switch assembly-1996 vehicle shown Disconnect the negative battery cable. Remove the instrument cluster trim plate by unfastening the retaining screws or simply unsnapping it. If necessary, remove the air outlet trim plate. If may be secured with screws/bolts or clips. If accessible at this time, detach the switch electrical connector. Remove the switch, using one of the following procedures: Unfasten the retaining bolts/screws from the switch, then remove the switch from the instrument panel. Unsnap the headlight switch from the instrument panel. If not already done, detach the electrical connector from the switch at this time. To install: Attach the switch electrical connector and fasten the switch to the instrument panel. If the switch is secured with screws, tighten to 18 inch lbs. (2 Nm). Install the air outlet and cluster trim plates. Connect the negative battery cable. With Head Up Display (HUD) (see Figure 5) Fig. 5: The HUD incorporates the headlight, fog lamp and HUD switches Disconnect the negative battery cable. Remove the steering column opening filler panel. Remove the instrument cluster, as outlined earlier in this section. Depress the locking tabs, then pull the switch out. Detach the HUD electrical connectors. To install: Attach the switch electrical connectors. Snap the switch securely into the instrument panel. Install the instrument cluster. Install the steering column opening filler panel. Connect the negative battery cable. Hope this help (remember comment and rates this). , You might try a crank sensor, most of the time if you pull it out you may see a crack in it. It's between the top of the oil pan an the transmission, good luck.