Detail: I recently had body work done on my car. Now my keyfob doesn't work and my tire pressure monitor doesn't work. I have already replaced the battery and attempted a reset of the keyfob. No luck. I do not have a manual to check out my tire pressure monitor info. 2008 Chevy Malibu. Tia
Solution: Take it back to the body shop an have them reset everything . Nothing you can do . Invalidate All This procedure will erase all keyless entry transmitters from memory. Install a scan tool. Turn ON the ignition with the engine OFF. With the scan tool, select Body. Select Remote Control Door Lock Receiver (RCDLR). Select Module Setup. Select Program Key Fobs. Select Invalidate All. Follow the scan tool on screen instructions. , Hi, a 6ya Mechanic can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck! , Your tire pressure is monitored by a device known as a TPMS sensor. Tire Pressure Monitoring System is an integral part of your tire that tends to wear with age. You need to take your vehicle to a reliable shop (I recommend Discount Tire) to have the TPMS sensor in the defective tire replaced. It's simple, and inexpensive. I have used Discount Tire's services for almost 20 years, and have never been disappointed with their service. , If this warning came up soon after the tire was replaced then the most likely cause is the tire installer damaged the pressure sensor inside the tire. They are easy to damage. , Do not..DO Not disconnect the battery ever! it wll cost you a trip to the vw shop to re set the computer....... bin there done that $46.00 , there is a reset button for the tpms either just above the accerlator or to the right of the glove box. press it and tah dah....you should be good to go. , Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.