Detail: I have a recessed light outside the front doors of my home and would like to convert it to a sense motion, how do you convert it without increasing the length of the recessed light bulb?
Solution: You will need to add a motion sensor in line between the power source and the light. , Hi, A 6ya expert can help you resolve that issue over the phone in a minute or two. Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US. The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones). click here to download the app (for users in the US for now) and get all the help you need. Good luck! , Unplug the electrical connector from your pop-up headlight motor(but not the headlight bulb), remove the plastic cover from the top of that same motor and manually turn the little gear at the top of that motor until the headlight moves up into the full upright position. It will remain there as long as the electrical connector stays unplugged. , Remove headlight assembly, Install 2 flashlights instead you ****. Junk that piece of ****.I wouldn't spend the 11 dollars for the bulb for one of those cars. , You may have this posted in the wrong product category. Please select another category appropriate to the problem and re-post the problem so the correct expert will see and respond to the question.. This is for car and truck problems. , It is true to keep the vehicle running till 100 miles in order to allow the ECU to map exact data for fuel air ratio. However, if the codes are pointing towards the catalytic converter, you might have to replace it. Was the sensor upstream or downstream? If it is downstream, the sensor has chances to go bad due to a faulty catalytic converter, since it does not filter the gases properly.